- CANNOT OPEN GTK GNUTELLA SERIAL
- CANNOT OPEN GTK GNUTELLA FULL
- CANNOT OPEN GTK GNUTELLA CODE
- CANNOT OPEN GTK GNUTELLA SERIES
NBAR is not supported on the following logical interfaces:Īre supported in Cisco IOS Release 12.2(18)ZYA.ĭialer interfaces until Cisco IOS Release 12.2(4)T Packets that originate from or that are destined to the router running NBAR. URL/host/MIME classification with secure HTTP.Īsymmetric flows with stateful protocols. Multicast and other non-Cisco Express Forwarding switching modes.
CANNOT OPEN GTK GNUTELLA CODE
Services code point (DSCP) field on the NBAR-classified packets and make MPLS map the DSCP setting to the MPLS experimental Use the modular quality of service (QoS) CLI (MQC) to set the IP differentiated
IP traffic before the traffic is handed over to MPLS. Multiprotocol Label Switching (MPLS)-labeled packets. NBAR can inspect custom protocol traffic for only 255 bytes into the payload.
CANNOT OPEN GTK GNUTELLA FULL
IOS Release 12.3(7)T, this restriction was removed, and NBAR now supports full payload inspection. Matching beyond the first 400 bytes in a packet payload in Cisco IOS releases before Cisco IOS Release 12.3(7)T. More than 24 concurrent URLs, hosts, or Multipurpose Internet Mail Extension (MIME) type matches.įor Cisco IOS Release 12.2(18)ZYA and Cisco IOS Release 15.1(2)T, the maximum number of concurrent URLs, hosts, or MIME type
CANNOT OPEN GTK GNUTELLA SERIES
Therefore, before configuring dNBAR on your Cisco 7500 series router, review the DRAM specifications for your particular To use dNBAR on a Cisco 7500 series router, you must be using a slot controller (or VIP processor) that has at least 64 MB This restriction applies to the Catalyst 6500 switches and to the Cisco NBAR is not supported with stateful switchover (SSO). This prerequisite does not apply if you are using Cisco IOS Release 12.2(18)ZYA. Prerequisites for Using NBAR Cisco Express Forwardingīefore you configure NBAR, you must enable Cisco Express Forwarding. Otherwise noted, the term NBAR is used throughout this module to describe both NBAR and dNBAR. The implementation of NBAR and dNBAR is identical.
CANNOT OPEN GTK GNUTELLA SERIAL
Used on the Cisco 7500 router with a Versatile Interface Processor (VIP) and on the Catalyst 6500 family of switches withĪ FlexWAN module or serial interface processor (SIP). This module includes information for both NBAR and Distributed Network-Based Application Recognition (dNBAR). This module contains overview information about classifying network traffic in NBAR. When NBAR recognizes and classifies a protocol or application, the network can be configured toĪpply the appropriate quality of service (QoS) for that application or traffic with that protocol. Network-Based Application Recognition (NBAR) is a classification engine that recognizes and classifies a wide variety of